Myson 15-10 Uživatelský manuál stáhnout pdf (Strana 14)

12 Myson, Inc. • 800-698-9690 • www.MysonInc.com

Kickspace Fan Convector Installation

MYSON EZ-Hose Kit

1. A kickspace heater must have a free flow of air through the unit. We have designed our grills to allow for sufficient

airflow. The opening in the kickspace must allow unrestricted airflow. (See drawing below.) Looking at the grill,

you should not be able to see any part of the kickboard. Failure to do so will cause the motor to overheat and

void the warranty.

2. The kickspace heater needs to be sized appropriately for the job. For proper sizing, use the ratings at normal speed.

If the unit needs to be in the boost or high setting to heat the room adequately, then the kickspace heater is too

small. Running the unit in boost or high for extended periods of time will shorten the motor fan assembly life.

The MYSON EZ-Hose Kit is designed specifically for use with the WH II 5000 and WH II 9000 Kickspace Heaters. While it

may be used for other hydronic products, MYSON will not be responsible for compatibility.

Components:

2 - 30" braided stainless steel hoses,

" compression x

" MPT

2 - Screwdriver slot ball valves,

" compression x

" FPT

Assemble the male end of the hose to the female end of the ball valve using the recommended Loctite #565 thread

sealant. Connect the compression end of the hoses to the stub-outs on the kickspace unit. Make sure that the return

side hose is connected to the top stub-out so that air will be forced through the heat exchanger to where it can be

removed at the air vent. Connect the compression ends of the ball valves to the appropriate supply and return pipes

from the heating system.

If the heating unit is below the main or

more than 4

feet horizontally from the

main, install two MonoFlo tees with the

supply arrows facing each other.

Cut cabinet kick

plate so make up

air can get in.

Cut cabinet kick plate so make up

air can get in.

WH II 5000 rough opening is 18

WH II 9000 rough opening is 22

Return

Supply

ON/OFF Switch Hot Air

Cool Air IntakeCool Air Intake

Cool

Air

Intake

Cool

Air

Intake

Fan Motor

Assembly

Mounting Screws

Cabinet

Kick Plate

Cabinet

Kick Plate

Copper Pipe

Water Flow

Return

Supply

12"

Keep Supply and

Return Tees 12" apart

1 2 ... 9 10 11 12 13 14 15 16

Komentáře k této Příručce

Žádné komentáře

Myson 15-10 Uživatelský manuál Strana 14

Komentáře k této Příručce

Související produkty a manuály pro Ohřívače vody a bojlery Myson 15-10